BIGTREETECH-Relay-V1.2 icon indicating copy to clipboard operation
BIGTREETECH-Relay-V1.2 copied to clipboard

Published 20 hours ago • verified publisher icon bigtreetech

Relay on ON by default.

Open yzheka opened this issue 2 years ago • 2 comments

I had a few moments when my printer was OFF and (for example at night) the electricity was shut down for a while. After it is recovered my printer is ON. Is it possible to change default state to OFF and turn it ON only using a button or pin?

yzheka avatar May 19 '22 08:05 yzheka

I had a few moments when my printer was OFF and (for example at night) the electricity was shut down for a while. After it is recovered my printer is ON. Is it possible to change default state to OFF and turn it ON only using a button or pin?

I have the same problem and support this feature request. It would be very helpful if an additional firmware file can be supplied where the default power-up state switches the relay off until the reset button is pressed. Alternatively, if the ST controller has capable flash memory, to restore to the state that the relay was in prior to the power failure.

DMT07 avatar Jun 06 '23 11:06 DMT07

One more thing. Can you increase shutdown and startup delay (+10 seconds will be enough) klipper doesn't starting up on time. thanks

talv2010 avatar Oct 13 '23 04:10 talv2010