vintagepc
vintagepc
This is a redux of #2499 for the new MMU infrastructure (closes #2478) Obsoletes #2499 Please note it's only been tested in that it compiles; I would like to gather...
### 🚨 Danger, Will Robinson! 🚨 this enables "Discussions" in place of the existing "Question" template, so you should: - [ ] **enable Discussions in the repository settings before merging...
After power cycle if filament is loaded, the MMU does not home and doesn't know what filament is fed. (Common if you leave a filament loaded to nozzle and just...
Encountered this today with F2 loaded to nozzle (Filament read "?" due to power cycle since it was loaded). Mk3S FW 3.9.0-RC w/ 1.0.6. Went to first-layer calibrate a new...
I've noticed that sometimes the selector will not home normally. Often it will do the "tap-tap-tap" routine but recently (possibly related to stealth mode changes?) it's started running into the...
Per the discussion in #39 - this adds an actual half-tone filter to the driver. It may also add some value to #37 to improve the output. The source for...
**Describe the bug** I've encountered two issues attempting to use this driver: 1. If I have disabled 'Auto-cut' in the options, the printer will not print at all. It completely...
Logging here for public discussion. On my wine installs with the current staging (8.5-lp154.1564.6) SolidEdge will start (and e.g. create a new part) but after a few seconds it will...
**Printer type** - [MINI] **Printer firmware version**- [4.3.0-RC1] **Original or Custom firmware** [Original] **Optional upgrades** - [Filament Runout Sensor] **USB drive or USB/Octoprint** USB **Describe the bug** On my printer...
Currently the speed HUD is not updated when the rocket is delayed and starts speeding up. This updates the variable to also update the speed HUD.