FU-Dyson-BMS
FU-Dyson-BMS copied to clipboard
tinfever
(Unofficial) Firmware Upgrade for Dyson V6/V7 Vacuum Battery Management System
The Dyson doesn't work when holding the trigger. The red light flashes. But when I detach the battery from the vacuum cleaner, then press the button on the battery, the...
> Cell balancing is not implemented. I know this is ironic, but because the cell balancing resistors aren't installed and Dyson used 1K resistors for the VCELL# connections, even if...
I am only getting about 1 minute of run time out of my v7's battery pack so I am going to replace the cells. When would be the optimum time...
I flashed the firmware successfully with a PicKit4 and MPLABS and took a dump of the EE-flash before I uploaded your firmware. It works fine, but the problem is the...
Flashed it with your software, seems to be working. There are 4 lights instead of 1 3 blue and 1 red, so slightly different reporting. After flashing had 8 red...
Im not usually one to post anything on GitHub. I usually download broken software from other people. Your software I was able to get working somehow. It gave me enough...
Hi, Thanks for made this project. It feels like give me a chance to fight against the sir James Dyson:) However, my bms maybe give it's life during the fight......
We talked in the comments on your youtube video, he asked me to open a topic, I'm writing it again.. I have installed the software, but when I plug it...
I tried to flash it using TL866II+ using PICLF1829 configuration because 1847 was not in the list It said ID was 0xA5 and disabled ID check to flash. I flashed...
Hi, just drop by to say you can just clear the pic eeprom and the red light will be gone and everything starts fresh the next time pic powers up...
