sunflowerABB

Remotely controlling the motor using the standard command works: `echo -n "MOVE,10,0" | nc -4u -q1 -w1 192.168.1.18 8888` when I try to run the motor.sh script as listed above...

Placing the mijia_crtl file in the /bin folder, the motor.php file in the /www folder and the motor.sh file in the /script folder I am able to see the simple...

One more critical point which I just discovered while debugging some more: the mijia_crtl binary must be running for all of this work! --------------------------------- # /tmp/sd/mijia-720p-hack/bin/mijia_ctrl UDP server started on...

Success report: placing the file "tf_recovery.img" on an empty SD-card formatted with FAT32 worked to recover my Xiaomi 720p camera

Sending this command manually from RFXMgnr works, but impossible from HASS

MDremote V107 works the same, however MDremote V108 seems to be different and doesn't work...

Alternatively, howto send an ID (i.e. 9147 as shown above) via ssh manually as a RF command using echo as shown below? What is the code pattern needed, i.e.: echo...

I received the following info from RFXCOM which I wanted to post in case someone else finds it useful: In order to activate "Undec Mode" on the RFXCOM it is...

Unfortunately I am unable to activate the undec mode using the command stated above - in any case not all signals are received by my rfxtrx once the echo command...

FYI everyone, here the answer from RFXCOM on how the code is put together: MD106 command = 14 03: Lighting5 command: 0A 14 03 03 00 91 47 01 00...