stephenflashtech

I am not too familiar with the GIT HUB process but I just fast tracked 2 designs done in a 3D modeling software. My immediate direction is to come up...

> I would recommend looking at the helpful engineering slack channel. It is a group of almost 10k engineers trying to come up with DIY and 3d printed medical equipment...

according to Oschner all of the fittings are correct. On Sun, Mar 22, 2020 at 10:54 AM vinnie90 wrote: > Have we figured out if the measurements are correct? >...

Thanks for the update. The plugs need to be made slightly smaller? can you let me know what the tolerance should be? Also can you send me images images of...

That sounds good. I do have the other design that might be the best of both worlds or can be adapted to this.       

I sealed this with silicone in the channels. We could adapt the 2 piece design to have one side slide on. The 2 piece design would be necessary if I...

I have sent these to Monark to print. Here are two new cap designs, one is 15.5 mm giving us a .5mm tolerance and one that is 15mm giving us...

Nima, send me an email directly and we can chat. [email protected] On Sun, May 3, 2020 at 9:39 AM Nima Moslemy wrote: > Hi, we are a team that needs...