covid19
covid19 copied to clipboard
scaleworkspace
Feedback on first print of Ventilator_SinglePart
The pieces all meet specs. The big issues are that the design doesn't give any room for the tolerance. The cap and the pipe it fits into are both 16mm diameter. As well while I can remove the interior supports, it's not pretty and I worry regarding any loose material that might end up stuck in there that could break free while in use
The large enclosed ventilator piece has excess water left in it as you can see from the photo. As well I think we'd do better to move onto the assembled version since we wouldn't need to print interior supports. However we'd need a way to seal it and I don't think we've got any medical grade glues or sealants.
Thanks for the update. The plugs need to be made slightly smaller? can you let me know what the tolerance should be? Also can you send me images images of the interior supports?
Let's get feedback from the Ochsner doc before we provide info that we are guessing about re: tolerances.
That sounds good. I do have the other design that might be the best of both worlds or can be adapted to this.
I sealed this with silicone in the channels. We could adapt the 2 piece design to have one side slide on. The 2 piece design would be necessary if I can successfully make the the butterfly valve version as you would need to get into the device to install the pieces. Let me know your thoughts on this. I also have
I have sent these to Monark to print. Here are two new cap designs, one is 15.5 mm giving us a .5mm tolerance and one that is 15mm giving us a 1 mm tolerance New Caps.zip
Hi, we are a team that needs your feedback to complete our idea. Please visit our pages and comment on it. github gitlab
Nima,
send me an email directly and we can chat. [email protected]
On Sun, May 3, 2020 at 9:39 AM Nima Moslemy [email protected] wrote:
Hi, we are a team that needs your feedback to complete our idea. Please visit our pages and comment on it. github https://github.com/nimamoslemy/ventilator gitlab https://gitlab.com/nimamoslemy/avp-ventilator
— You are receiving this because you commented. Reply to this email directly, view it on GitHub https://github.com/scaleworkspace/covid19/issues/13#issuecomment-623120215, or unsubscribe https://github.com/notifications/unsubscribe-auth/AO3DE6TSK2CJTRDUDRNKWD3RPV623ANCNFSM4LQPOKZQ .