David Miller

I am also seeing this issue

> I think the issue is with "Wipe while retracting" not working at all. > > **"Wipe while retracting" disabled, "Retract amount before wipe" set to 100% or any other...

> Wipe on retracting is not occurring for me.  And similar for your issue, if you zoom in on the rightmost inner wall,...

I'm seeing some very similar issues on my X1C with there being a seam gap despite adjusting the likely culprit parameters: set seam gap to 0 and 0%, dried filament...

Here is a simple test case I use which recreates the seam issue I'm seeing with the X1C. I'm wondering if others can run this test and also recreate it...

I've played around with various settings and I still haven't identified the issue or found what I would consider a good solution (I've messed with a lot of different factors...

+1 also seeing this issue

Bumping since overhang/bridge overlap is still an issue

@hotellonely What's really strange is that the "fix" with setting the Bridge counterbore holes setting to "Partially bridged" seems to use the same routing that an internal bridge would but...