Waldek comments

Results 99 comments of


                                            Waldek

WIP: Pj sip logic

Hi, I did the first tests using the Adi DL1HRC pjSipLogic solution that allows you to connect svxlink with VoIP asterisk. I have connected svxlink repeater to asterisk that is...

WIP: Pj sip logic

Today I did tests of connection with VoIP softphone VoIP jitsi https://jitsi.org/ The connectivity was very good because I was able to set higher microphone gain. In case of Cisco...

WIP: Pj sip logic

It is very useful to hear the characteristic Beep heard on the SIP phone on after finish speaking. It would be nice to have this beep after the end of...

WIP: Pj sip logic

Adi, At current, is it possible via DTMF connect from radio to SIP phone number? I have on Asterisk Conference bridge, for this reason, it will be nice to have...

WIP: Pj sip logic

Adi, I tried to send out a command echo "C6000#" >/tmp/sip_ctrl but in the log is Fri Mar 29 18:46:51 2019: SipLogic: Calling "sip:[email protected]" Fri Mar 29 18:47:36 2019: SipLogic:...

WIP: Pj sip logic

Adi, I have updated new pjSipLogic. Regex working with default seting I can connect to svxlink Sat Mar 30 15:56:10 2019: SipLogic: Incoming Call from 747120636241 [] [email protected]:5060 Sat Mar...

WIP: Pj sip logic

Adi, I have send following echo: echo "C6000##" >/tmp/sip_pty I have put two ## on end number and now in log is Sat Mar 30 16:11:13 2019: SipLogic: Calling "sip:[email protected]"...

Adi I have changed SipLogic.cpp in 844 line tocall += m_dtmf_incoming.substr(1, count-3); to tocall += m_dtmf_incoming.substr(1, count-2); now in log is correct without cut last digit from phone number Sat...

WIP: Pj sip logic

Adi, I have in svxlink.conf: #AUTOCONNECT= but during start of svxlink in log is: Sun Mar 31 10:00:31 2019: Starting logic: SipLogic Sun Mar 31 10:00:31 2019: SipLogic: *** WARNING...