Mark Burton
Mark Burton
FWIW, I still use lines pattern rather than zigzag for bridge skins myself.
I think I have found the cause of this issue. There's a hard coded distance used to determine when two vertices should be melded (i.e. considered the same). It is...
https://github.com/Ultimaker/Cura/assets/585618/5b2250f4-4f33-411a-8eae-d12f8a76290c
Cura works in uM, the smallest distance it can represent is 1 uM. However, because it's doing a lot of calculations that involve transformation of coordinates small errors can creep...
FYI - release 4.20.21 is now available and it has a new setting that lets you change vertex_meld_distance. If you try it out and have any problems or requests, please...
The required change is trivial. UM could easily incorporate a similar change in their Cura.
Hi, it's an interesting idea and probably not too hard to implement. I will look into it this week.
I have an implementation. I added a setting for the outer wall line width used on even layers. Will test it a bit and make a release before too long...
I have just made a new release that embodies this feature. You can find it at https://github.com/smartavionics/Cura/releases. If you have any feedback/issues when using it, please open an issue at...
This artefact is an unfortunate side effect of how I have implemented the layer view for the Pi. Due to the fact that the Pi has a rather low power...