Mark Burton
Mark Burton
Thanks for giving it a go. I would say that the middle and right test parts are pretty similar. If anything, the middle part shows more infill width variation than...
Thanks for the measurements. > Center part, same gradiant infill but with a Gradiant Infill Speed Factor = 50% : 0.47 - 0.73 - 0.26 - 0.74 - 0.5 Don't...
I still don't understand why a bowden extruder should behave as you are saying. What I think is happening in your case is simply that the extruder/hotend cannot deliver 200%...
At the end of the day, it's probably a combination of factors that stop the extruder/hotend performing as well as we would like. Anyway, I am going to make a...
New release now on dropbox 20200218, please give it a go.
The fast and slow schemes both modify the print speed so that throughout all of the infill, the extruder will turn at the same speed. So for both schemes, when...
And what happens when you turn off support?
If retraction is enabled, it will always do a retracted travel move to the location where the first line is printed.
@jbeima, can you please try this build? I'm hoping it will pick up your system libssl. If it runs, check that you can load the marketplace window as that requires...
https://github.com/smartavionics/Cura/releases/download/4.20.5/README.pdf