Slic3r
Slic3r copied to clipboard
slic3r
Open Source toolpath generator for 3D printers
**Is your feature request related to a problem? Please describe.** Slicing software cannot generate paths from perfectly valid surface models and artificially thickening surface models in mesh or solid modelers...
**Describe the bug** Slic3r won't build properly on my Debian system using the recommended instructions for UNIX/Linux. The following errors are seen: ``` $ cmake .. ... CMake Error at...
Hi there! Slic3er seam options have been getting better over the years and think it handles seam the best out of many slicers out there. I wonder if its possible...
**Describe the bug** When changing any slicing setting under print, filament or printer menus, either in their tab, or on the side menu shortcuts, slic3r stops responding for some time,...
Meshes in .obj or .stl file imported into slic3r that are far from 0,0,0 cause a crash. Re-exporting the mesh from near the center allows the file to be imported....
### Version 1.2.9-1250-g8ca6171a ### Operating system type + version 11.1-STABLE FreeBSD 11.1-STABLE #2 r322118: ### Behavior Compile warnings and errors in src/admesh/stlinit.c:30: ... use of undeclared identifier 'letoh32' ... This...
- http://hackaday.com/2016/07/27/3d-printering-non-planar-layer-fdm/ - https://github.com/makertum/non-planar-layer-fdm Is this something we should look into bringing into upstream? Tagging @makertum to bring into conversation
The tooltip shown when you hover over "Pressure advance" setting states " Reasonable values are in range 0-10". However, if you actually do some testing you'll see that values above...
This change alters the .github/CONTRIBUTING.md file to use the new IRC server.
I still use Slic3r to verify my models are error free. But it does not give any information as to WHERE in the model the errors are. Since they have...
