Simon Kirby

Hello! Uhhmmm, you have a lot of unrelated hunks in your pull request (adding and removing whitespace?), but I think you are trying to correct "Eisable", which is actually supposed...

Right, but this was originally intended for multirotors where there isn't much that can be done when the battery is detected as low. It would be better handled in the...

Hello! At a quick glance, I'd guess they're tgy.hex-compatible, as there is no external oscillator and two chains of transistors for discrete FET driving. I'd say try flashing one with...

Hmm. I have no idea what firmware they are using on those. There is nothing I can think of that would (intentionally) result in that. Did you ever figure out...

Hello! Starting a large mass might be helped by significantly lengthening the TIMEOUT_START. It can actually be set to any 24-bit value in microseconds (stored in ticks, so the value...

Hello! I just tested this and didn't get the same result. Are you sure you're using a version since 02bd8e4ca? I guess that wasn't released until yesterday.

Hello...Please let me know what setup you have that isn't working, since it works for me (tested a few ways).

OK. I did check earlier with a home-made servo tester, but ran out of time and had to go to work. The servo tester I made uses a DAC output...

afro_nfet.inc is probably the easiest to use for a schematic. The stickers are supposed to say what firmware they have, and the .inc is what is used to describe the...

Hello! Yes, but finding it automatically is currently not supported. I'm not sure how it might be best to find this automatically. Meanwhile, Owen has a calculator here: http://owenduffy.net/rc/tools/bldca.htm