AqualinkD
AqualinkD copied to clipboard
sfeakes
Daemon to control Jandy Aqualink RS pool equipment from any home automation hub (Alexa, Homekit & Siri, Home Assistant, smartthings, domoticz etc) or web browser.
With a dual mode device (e.g my RS-2/6 Dual), the Pool temp was being set to TEMP_UNKNOWN on a status message when the spa pump was on. This seems to...
I'd like to install a Pi Zero behind my control panel and I think it could be cleaner using a TTL-RS485 adapter.
There is an issue with the pool temp being displayed only when the temp message is sent if using "low speed" pump mode. This mode is enabled using S1 Dip#2...
This is similar to a recently closed issue #85 regarding SWG's bouncing between X% -> 0 -> X%. I have been having this issue since updating to 1.3.6 although I...
After successful setup and connection to my MQTT Broker: ([Mosquitto Add-on for Home Assistant](https://github.com/home-assistant/addons/tree/master/mosquitto)), running on another server, I was noticing frequent disconnects from the broker every ~2 minutes with...
Following the guidelines in the Wiki, you should be able to do the following: ``` Timers can be set on anything with on/off /api/Filter_Pump/timer/set (value in minutes, will turn device...
Tried to change the VSP speed today via the Web UI. The speed would not change. Only had logs set to Notice so did not capture detail. Restarting service seems...
see ballle98/AqualinkD#53 request for button "spa_heater" was matching button label "spa" because the sting comparison was only going to the length of the label. Strings need to match in length...
After Updating to 2.2.2, I see WARNINGS in the logs whenever the browser is connected. Looking at the json code and other things it looks like the browser will send...