scottjvincent

I just follow the previous bltouch thread about it locking up and tried those settings, now it works perfect fixed my BL touch with the new motherboard https://github.com/bigtreetech/BIGTREETECH-SKR-E3-Turbo/issues/24

So I just made the firmware changes to show chamber temperature which would be the motherboard temperature turned the stepper motor amps down from the default 800mAh to 600 mAh...

So i got it to do it again and the terminal in octoprint says this. Recv: E driver error detected: 0x1075773584.0000000000000000 Recv: coil short circuit Recv: X Y Z E...

Soo I uncommented "fan_soft_pwm" And the fan started working like it should variable from 1-100% woohoo .. But what I don't get is I didn't have that option enabled before...

I had the exact same problem with my ender 3 v2 , after I upgraded and went with the newest Marlin build it saves to epromm no problem

I did the 2.0.8.2 main build..... Tried absolutely everything first.... Ever firmware setting I could think/read of...... And finally installed the current version and went though the entire firmware beginning...

Ya I tried that also with the older version and it didn't work for me.

> @Z3r0Auth > All you have to do once is create the configuration and then it is never a problem to upgrade to the new version if you are using...

Just tried those settings on mine with bltouch not working and it fixed it, thank you very much