Vikram Sarkhel
Vikram Sarkhel
Unfortunately due to the design of the printers mainboard and limitations in the Linux USB gadget subsystem. I don't think we can use the USB_OTG interface as a mass storage...
The Anycubic Photon S filetype is supported and it should work if you've properly setup the serial connection. The printer isn't listed under supported printers because I don't have access...
Did you try using the RX2, TX2 pins?
Those pins are probably for connecting an ESP-01S for WiFi. You should be able to use those pins. It might also work for the Anycubic Photon S. I suggest asking...
I'll look into it this weekend. It could be due to some error in how I'm handling the gcode receive loop before its passed into the comm layer.
No, it's been hard to track down the cause of the bug.
You can use the Raspberry pi 4B if you want. Thats what I used when I developed the plugin. I just recommended the Raspberry Pi Zero 2W because I personally...
The Zero 2W can handle everything, I use it to run Octoprint for my Elegoo Mars 2. I think some people have tested it with the Anycubic Mono SE but...
Sorry about the delayed response, I've been busy with work and life. The issue could be due to an issue with the cable. But I'm not planning on supporting the...
Personally recommend using Lychee slicer since the UI is better but that's a personal preference. I have thought about making failure detection model for resin printing since I work in...