Vikram Sarkhel
Vikram Sarkhel
The encryption key can be scraped from Chitubox. The plugin uses the file contents to get the file metadata and serve it in the dropdown menu. Also other parts of...
The printer isn't mounting the USB mass storage device for some reason. Did you properly connect the micro USB cable to from the USB-OTG port on the pi to the...
I'll work on fixing the issue. Can you send me the file that caused the original issue? Also what version of CTB file was it and which slicer did you...
It should work if you connect the RX and TX pins to the serial port used by the WIFI chip. I don't own an Anycubic photon Mono X or have...
The Anycubic Photon mono SE should also work if you disconnect the USR-C322 chip being used for wifi and connect the RX and TX pins to the serial port used...
> ## Problem > I had a look into my printer. Unfortunately there's no mirrored UART port. > > ## Solutions > ### UART > So you basically have 2...
> So, I will go ahead and say, that just removing the Wi-Fi modules isn’t enough to integrate. I haven’t been able to inspect the serial traffic, but it isn’t...
The delay on the Z changes is due to the code updating the when the file percentage increments by 1%. Its an inaccurate method I'm going to fix it once...
Can you send me a picture of how you hooked it up. I need to create a wiki with hardware setup pictures eventually. Also I did some research about your...
The M110 is due to an issue with how the firmware handles the M110 set line number command. You should add M110 to the blocked commands list and change "Send...