Roman Tyr

more layer heights were added for high-flow nozzle profile variants

Yes, but 3rd party printer profiles are mostly about community contributions.

I am afraid this is not enough to add that printer. There is only one basic printer/filament/print profile called "Kobra2-PLA Parameter", also the way it was added to the ini...

More print profiles (for example different layer heights). At least some basic filament profiles (PLA/PETG). Those profiles should be tested/tuned on actual printer. Basically what would you expect as an...

That is not planned. On the contrary, we will possibly remove legacy "non-IS" profiles for MK4, or move them to some legacy section of the wizard. Input shaper is firmware...

Do you have profiles/settings for it?

As far as I remember the original author of the Sovol profiles @ils15 got those profiles directly from Sovol. The wipe tower may be still needed on idex printer to...

Do you have profiles for those filaments?

Can you provide tested profiles for these filaments?

We are not planning to add more nozzle diameters in the near future.