PrusaSlicer-settings
PrusaSlicer-settings copied to clipboard
prusa3d
add the 0.30 Printer settings profile
Hello,
In the mk3s 0.40 printer settings I had the 0.30 Printer Settings profile. This was an perfect setting for speed and quality. Could this profile add in the next release?
Chris Gerrist
It made sense on MK3S, but not so much on MK3.5, since even 0.20 SPEED already prints so fast, that it is close to the volumetric speed limits of the hotend (how fast can be filament melted). 0.3 layer height would need to be printed much slower.
Hi,
Today I made a print profile 0.30 for the 0.4 nozzle. Same as the Prusa mk3s profile. The print looks beautiful. I didn’t had any problems at all.
Chris Gerrist
On 23 Apr 2024, at 07:19, Roman Tyr @.***> wrote:
It made sense on MK3S, but not so much on MK3.5, since even 0.20 SPEED already prints so fast, that it is close to the volumetric speed limits of the hotend (how fast can be filament melted). 0.3 layer height would need to be printed much slower.
— Reply to this email directly, view it on GitHub https://github.com/prusa3d/PrusaSlicer-settings/issues/251#issuecomment-2071427939, or unsubscribe https://github.com/notifications/unsubscribe-auth/AABO7CXDLNPO77JKKULA4BLY6XVNNAVCNFSM6AAAAABGRJYFNGVHI2DSMVQWIX3LMV43OSLTON2WKQ3PNVWWK3TUHMZDANZRGQZDOOJTHE. You are receiving this because you authored the thread.
It will print fine, but slower. The speed is limited automatically by volumetric speed limit.