rstrouse

Interesting. I thought we had users with IntelliFlo / pro VSF already. If you want real time display of the messages you can use messageManager. https://github.com/rstrouse/nodejs-poolController-dashPanel/wiki/Message-Manager It is possible that...

Are you seeing wattage and rpm on EasyTouch?

Good luck. I am not so sure that flash isn't the failure point. Maybe we hit something that trashes the firmware but it didn't seem that a byte sequence sent...

Yes you have found the blinky blue mode. Originally I thought this might be the valve waiting for input from the master but never could get anything else out of...

It is interesting that if you send a 240 out to address 12 all valves will respond with a 241. However, if you have a bit of RS485 understanding the...

Well that certainly jives with our experiences. I have 2 valves that are inop after beating it with 245s.

I have 8 IntelliValves currently installed. Happy to help where I can.

I'll have a look. We have seen this heater on the ET8 and IntelliCenter. When it is off it should be reporting off if it isn't in the cooldown mode....

Pull njsPC. It appears EasyTouch reports that the heat status is heatpump even though the mode is off. However, I did notice that the information we had on the heater...

By all means yes. Unfortunately, we have none of this equipment, just a user base with all sorts of it.