rflulling

> Thanks for trying that out for me and confirming. With the fricking day I've had I thought sod it and brought some cheap tmc2208's, I believe they are standalone...

> Hi again. > > I understand everything but this: > **Now from the menu, select "Configuration" then "Restore failsafe." Not doing this will result in previously loaded possibly bad...

> Thought I would give it one more try just to make sure - have not looked back since getting the 2209's - using "freshly" downloaded marlin 2.0 and rflullings...

Bear in mind the more you Change from a known good working file the greater the odds something you have changed will cause you trouble again. There is nothing wrong...

I check the behavior against others that are known good. Though i have never killed all of them. Controller>Driver X>Cable>motor G90 G0 X100 F300 If the flat side is parallel...

at this point, I think we need to see what each of you are working with. A quick look at the controllers, wires and drives, and the watch the motion...

Not at all sure what if anything I could show that has not been explained. What are you looking for? Further any movies are A relative to my unique configuration....

A4988 are hardware defined stepping. You do not need to configure Marlin for this and you can leave the stepping in the configuration files commented out. See my previously attached...

I really would not argue that I am the only one to get this to work. Many start out with A4988. Some of you are having an issue that is...

The Marlin 2.0 branch, the official version should support the USB port. I think there is also a define for it in the configuration_adv On Sat, Jan 25, 2020 at...