Ray

I tested ArduinoPusherLibrary with UIPEthernet today. Seems to be working fine. Just make sure you change the #include in WebSocketClient.h to use UIPEthernet.h.

I am not aware of this issue and have not heard of other report of this issue. Is it possible that you are using a relay module that's active low?

I think this issue is because when the door is open, the car status defaults to unknown because normally the door would block the car so it's not able to...

We tested the firmware with mosquitto in Linux and it's correctly sending MQTT messages. I am not sure about the HA integration. You may have to post this as a...

This issue should be fixed in the now released firmware 1.2.0. Previously 1.1.2 beta was using fixed port 1883. This has now been fixed.

Could you justify the need for this feature? With the current firmware, you can choose to use switch sensor, and set sensor logic to Switch Sensor only, which allows you...

This can be improved. The lag is technically only needed if you are using the built-in distance sensor. Because the distance sensor can be noisy, and transient events like a...