Rakor

Same here with US-International keyboard. I can not type the following in Revolt: " '

I used: `Command line tool to interact with Nitrokey devices 0.4.46` I can wait 10 minutes after starting `gpg --card-status` and nothing happens (LED shines blue-greenish). I unplugged and replugged...

Here they are: ``` > ./nitropy-v0.4.46-x64-linux-binary nk3 status Command line tool to interact with Nitrokey devices 0.4.46 UUID: 9B1260C79FC442A40000000000000000 Firmware version: v1.6.0-test.20231218 Init status: ok Free blocks (int): 226 Free...

Yes, I unplug the NK3, plug it in again, and even then it is not responding. As I have no oct, and don't want to mess with my working debian,...

OK, I created `~/.gnupg/scdaemon.conf` with the content you provided. As expected, same result. But the log-file is not written (I have also tried to write the logfile in the home-directory,...

I sent you the output through Matrix.

Thanks a lot. I did the `nitropy nk3 update --version v1.7.0-rc.3` and the `nitropy nk3 factory-reset-app opcard --experimental` After this I had the same result: led stays on, gpg hangs....

Installing FreeBSD using its installer (bsdinstall) with zfs and geli you'll get exactly this setup. So it would be nice to have this standard-setup being supported. :) Will you address...