ptvo
Hi, Unfortunately, it is a mistake to use cc2652p.hex without configuration. It is a template only. SBL is not active there. Now, you need a XDS110 or similar JTAG flasher...
It is useless because the SBL pin should be configured too, and it may change for different boards. I've updated README and added this caution.
Currently, SBL isn't activated at all in the template HEX file. Sorry.
@janmashat Probably good new for you. SBL is enabled in the firmware, but the SBL function does not use any pins to activate it (Auto BSL). I know, there is...
Sorry, it is the very rare case. It is too hard to implement this feature
What do you mean by ""on" time varying from 1ms to 2ms"?
Hello, Did you enable periodic reports on the "Expert" tab?
Please ensure that the sensor woks. Try other pins (for example, P02, P03). I've verified this sensor, and it works as expected. 
Currently, the firmware cannot send or decode IR codes.
Why is it better than other temperature sensors like HDC1080, DS18B20, etc?