psyborg55
psyborg55
well, i loaded fw blob extracted from system bios of this laptop and after dismissing warnings it shows correct PCI IDs and SUBIDs.. unfortuantely that is the only info shown...
> Then I upgrade wget from 1.5 to 1.9 wtf you sayin, 1.9 is from 2003.
Maybe not the same problem, but is also noticeable on Eutelsat 7east channel CineFilm. AMD GPU as well. I think channel use L4.1 format, while most others are L4.0
qca_dram_cas_lat(void) function is returning reg/2 shouldnt it return reg-1/2 when latency is set to 2xCAS+1?
PCIe: no device, 168C:003C is like this: PCIe: PCIe slot 0, PCIe slot 1
any specific configuration on these two units in regard to the other two? did all the units ran the same firmware image? have you overclocked any of them?
I wasn't referring to HW revision, but rather on software configuration e.g. WiFi mode AP/client/WDS, or Ethernet config bridge/WAN etc. Also how were you able to determine the cause is...
Came across my mind too. These devices usually come with different RAM chips even in the same revision. At least I've seen winbond and zentel versions, possibly there are ESMT...
@Leo-PL did you ever got a chance to open problematic units and check memory chips? maybe they are W9751G6KB-25 ?
Ok, thanks. Wondering if lower memory voltage could cause any instabilities, default on my v1 is 1.69V, stock u-boot sets it to 1.83V. It can be changed in 50mV steps...