Original-Prusa-MINI
Original-Prusa-MINI copied to clipboard
prusa3d
Original Prusa MINI 3D printer hardware
A small guide on the back of the printer electronics base for both cables so LAN and power. This would help a lot when plugging the cables into their sockets...
I have seen [thomas video ](https://www.youtube.com/watch?v=eGUPBoDxmKk) and I have done the 3 tests, thermistor tests work ok, but doing the heater one won't work, it should stop heating or reboot...
Irregular, loud rear fan noise not caused by debris continues to be a mystery.
Perhaps consider using helical gears for the extruder mechanism, to minimise backlash/noise. At the moment this is the most annoying/noisy part of the printer. Or perhaps stay with spur gear...
The mini might be modified or is (maybe) in the need of a higher airflow for the hot end, see respective threads [ here](https://forum.prusaprinters.org/forum/user-mods-octoprint-enclosures-nozzles/strange-extrusion-problem-using-bondtech-extruder-and-heat-break-on-prusa-mini/). Currently, correct me if I am...
Bed leveling data is not used, even if doing first layer calibration if you have not selected a sheet profile previously. I guess this happens only after upgrade from pre...
I've encountered this issue on one of my printers, even though it worked perfectly fine out of the box. Issue #40 may be related. Either due to deformation or conflicting...
Seeing the good attitude towards open source hardware, software and mechanic design at Prusa Research marks a new era for me. An innovative, fast growing company that benefits from sharing,...
OpenSCAD?
Is there a particular reason that this wasn't designed in OpenSCAD as per the usual tradition? Thanks.
My Recommendation: Update part per my design. Extend length of arm slightly and have a thru-hole for the nut. Place the nut all the way on the back side of...
