osvikvi

HEllo, I too had some issues while installing this newer version. I already have a 3b+ and two zero-s running RPOS. Since a couple of days I-ve been trying to...

thanks a lot, I've never tried mpromonet actually I understood Gstreamer was suggested for use with usbcam. I'm installing it now.... Indeed, the pi reports: "Only Gstreamer RTSP is supported...

Thanks for the suggestion, I'll try to figure it out. Actually I'm using a 10€ UVC - HDMI->USB in combination with Tandberg / Cisco VISCA PTZ camera's.

that was my idea as well, I have a whole bunch of those Tandberg TTC08 camera's and wanted to benefit the great optics and PTZ functionality. but only one is...

Success, I could manage to get a decent image STREAMING 1080p @2fps HDMI over usb In rposConfig.json set "RTSPServer" : 2, In camera .js,: disable the line that prevents from...

Thanks, I think so too ;D... It's all in camera.js I could enable verbose logging on the bottom and apparently the server still pushes 25fps while higher up, I requested...

actually it's Hexadecimal values, I don't think I can translate this into text, Can I? Correct me if I'm wrong but which serial device is expecting text commands?

Thanks for the tip, So I've converted my Hexadecimals to decimal values and sent that to SPJS `send COM3 170 17 254 1 0 16\n {"Cmd":"Queued","QCnt":1,"Ids":[""],"D":["170 17 254 1 0...

Than I just don't understand what I 'm doing wrong. Can you confirm I need to send nothing more than "open com3 9600" and "send com3 + commandstring" Actually it's...

Hi, I think it got solved in the end, but honestly I can't remember what it was that did the trick. All I can remember is that I still have...