uavcan4hobbyists
uavcan4hobbyists copied to clipboard
olliw42
STM32 32-bit microcontroller based UAVCAN nodes for DIY
Hi olliw42, is it possible to provide the PCBs in gerber format, as this seems the most widely accepted one? Best --Seeelefant
Hi @olliw42 congratz I'm using your uavcan and is amazing. Any change to publish the power brick board and bom ? Thanks a lot.
Hello, I just wanted to thank you first for the betacopter firmware! It allows me finally to have ESC telemetry on our octocopter and it works perfectly. Because we would...
Hi Olliw, Thanks a lot for the great work! I would like to add the support for another range finder, the jsn04-t v2, in a few words: -baud rate 9600...
I have been successful to build slcan adapter and also I can connect it to any modules of UC4H but I cannot connect Sapog ESC . when connect to the...
Hi dear developer I built on of mt own SLCAN Adapter using you schematic and flash binary file in your github every time I connet my adapter with WIN10 using...
Hi dear developer I built on of mt own SLCAN Adapter using you schematic and flash binary file in your github every time I connet my adapter with WIN10 using...
Dear developers! Where may I find the source code of `SLCAN Adapter`? It seems you provide only hex file. But I need at least a bin file to use it...
Not sure of the cause, and it’s most likely the problem is at my end - so this is more a note for users than an ‘issue’. For me, downloading...
Hi! I've exported 3d model for your UC4H ESC adapter in its current stage. It is eagle-to-sketchup, so STEPs are not an option. But this may help if you want...
