dji-firmware-tools icon indicating copy to clipboard operation
dji-firmware-tools copied to clipboard

Published 20 hours ago • verified publisher icon o-gs

Mavic Mini Linear Hall calibration failed

Open Agrestbar opened this issue 3 years ago • 4 comments

Screenshot_20201117-011435 Hi there! Just tried to perform the calibration of the Linear Hall sensor but it failed. Do you have any ideas what should i check when it comes to the hardware problems? Which part is responsible for the linear hall sensor calibration?

Agrestbar avatar Nov 17 '20 00:11 Agrestbar

Был ответ от "Мефистотелис" по этой проблеме! Но я пока не разобрался! Нужен пример!) "Чтобы это исправить, нам понадобится ответный пакет. Запустите команду с параметром «-vv» и вставьте полный журнал. Он должен содержать ответ в виде шестнадцатеричной строки."

Denis14071982 avatar Nov 24 '20 19:11 Denis14071982

The "Unrecognized response" error has no effect on the actual calibration.

Also, please use English.

mefistotelis avatar Nov 24 '20 19:11 mefistotelis

Thanks! That does not affect, I was convinced! But how to remove the message in DJI Fly with code 40011?

Denis14071982 avatar Nov 25 '20 05:11 Denis14071982

hello i have the problem with gimball calibration of my MAVIC MINI .After crush i have put a new cable on the gimball, but i can see only the camera but the gimball dosn't move .Also after calibration , nothink happen , only the JointCoarse move a little be the gimball , but the other command nothing do . If you have some suggestion , please let me know . sorry for my english

MarcoBarba77 avatar Feb 13 '21 14:02 MarcoBarba77