musapinar


@tomasAl Yes. If you stick to my drawing you should be OK. My schematic was fine but the way I plugged that 1k resistor between TX3 and RX3 was potatoe....

I noticed even though move/presence sensitivity reset back to zero for unknown reasons, that it the case only in the z2m UI (on the sliders). The entities states in the...

I've ordered a Tuya hub so that I can further investigate. I intend to unpair from z2m, pair to the Tuya hub and set the ZY-M100-24GV3 via the SmartLife iOS...

Just received the Tuya hub and paired the device with SmartLife. - The app says it's a "V2", while z2m registered it as a "V3"   - Sadly the...

I have 2 devices that do reset their values every 10 minutes very precisely. It also resets values after it has detected a presence, then again a few times every...

@jjfs127 This automation runs only when HA restarts (typically after an update or if the circuit breaker has been turned on/off since this device does not hold settings but resets...