Miguel Risco-Castillo

icon indicating a website link http://mrisco.accesus.com

icon company PULSAR icon location Lima, Peru icon location FPGA system architect with experience in embedded and microcontroller devices. Software, hardware and firmware development.

Results 216 comments of Miguel Risco-Castillo

Auto mesh isn't working

Hi, this is not a general printer support forum. Many problems can be easily solved by reading the firmware [Wiki](https://github.com/mriscoc/Ender3V2S1/wiki#main-topics) please check the calibration guide. This Issue Queue is for...

[BUG] Numbers in auto leveling not shown unless bed tramming wizard is run first (TJC)

> Miguel, when is there a next release? I still have to do a bedtramming wizard first before i see numbers in my screen when it uses aml. Is there...

[BUG] Numbers in auto leveling not shown unless bed tramming wizard is run first (TJC)

> Hi Miguel, > > Thank you for your quick response! I wanted to check if I’m one of the few experiencing this issue, especially since there hasn’t been a...

[BUG] Numbers in auto leveling not shown unless bed tramming wizard is run first (TJC)

Hi, this bug has been fixed in the September 2024 source code, you can compile it, request a compile service in the Patreon site or wait to the next release...

Provide cleaned up small icons for DACAI screen

Thank you for your contribution, I will leave the mod here so anyone can download your new icon set.

Probe stowed during mesh levelling, Z-Axis still goes down

Hi, this is not a general printer support forum. Many problems can be easily solved by reading the firmware [Wiki](https://github.com/mriscoc/Ender3V2S1/wiki#main-topics) please check the calibration guide. This Issue Queue is for...