Miguel Risco-Castillo

Did you maximize and center the mesh insets? https://github.com/mriscoc/Ender3V2S1/wiki/Calibration-Guides

I did some probe positioning tests and were successful, mesh is correctly centered after the maximize/center procedure. Re-check you probe offsets values, maximize and center must be the last step.

Some probing positions are unreachable and that depends on the probe offset. With lower probe offsets you must be able to decrease the margins and increase mesh area. If you...

For Q&A please post in https://github.com/mriscoc/Ender3V2S1/discussions

Currently, for printers with the Sprite extruder Pro you should use the special T13 version from here: https://github.com/mriscoc/Special_Configurations/releases/tag/T13 that version has the correct thermistor calibration table for that extruder, you...

No more feddback

Currently It is not possible, the DWIN/DACAI screen has a reduced number of chars in the internal font set.

https://github.com/mriscoc/Ender3V2S1/wiki/Filament-Settings-Menu#run-out-sensor

No more feedback

The printer MUST know the current axes position before to go to the park position. Therefore, it is important that the printer axes have been homed before, you can check...