mikeFandA

There are maybe a few cases where you would start from the outside and move inwards, but generally from a machining perspective it greatly reduces stress on the tool to...

Ahhhh yes my mistake I completely misread the image above, yes I was refering to milling pockets from the centre I had read the image as a set of pocket...

For the coding issue, It's hard to see without looking inside the cluster and I'm not at a computer with grasshopper right now. I would say on intuition that going...

Yes that was what I was getting at or something alonf those lines. Essentially you would loop through the cruves and test each start point for inclusion and use that...

If you´re open to other plugins you could look at human, it has various interface components that help with this kind of thing. Another option is to setup up a...

It may be worth considering the material density and part-holding method too. The stiffness of the part as a whole during machining will contribute greatly to the resonance created during...

No problem, happy to help! The material qualities could be an optional input to give faster cutting, so if the user doesn't input anything it defaults back to the conservative...

A possible solution could be to set the start point of the curve manually using a set parameter such as a cp operation based on the work plane origin. That...