Lukas Chrostowski

@khavasi, Good point. Will change the template files to use 450 nm waveguides rather than 500 nm. For your device, you can assume the input/output pins will be 450 nm.

@khavasi I fixed the pins to be 450 nm in the GDS files. a369b1f405d2d64765e72e405bed57dda47dbe23

@gbfarias Giovanni, The process we will be using includes oxide. We will fabricate your design using two facilities: 1) University of Washington, and 2) Applied Nanotools. Here is a description...

@GerardoCastanon, Dear Gerardo, The requirement for having the output waveguides be separated by 2 µm is so that the splitter can be used in practical applications, namely where we have...

@vatalogg, Vasileios, A) Min feature size of 60 nm, means that the minimum distance between any two pieces of silicon has to be 60 nm or more. A trapezoid (e.g.,...

@khavasi I just turned on the openEBL submission system. I turn it off on each fabrication run. I see your openEBL*.gds files are there.

Here is a video excerpt from an edX Phot1x Live Q&A, where I discussed how to simulate a component from a layout in KLayout, using Lumerical FDTD. The simulation generates...

Dear Luhua Based on what you read about waveguide separation, what I have drawn (2.5 center to center) should be sufficient. In terms of the space, you don’t need a...

@LuhuaXu : Correct.

@LuhuaXu, Journal publication: of course! SEM: yes, we can take a picture of your design. To request an SEM image, please place a box over the region of interest on...