kipper2k

Hi, Thanks for the info. I will post all my files, gerbers and eagle, and if i get ambitious i will learn kicad. It will be an a500+ board but...

> I built this SMD A500+ and it works (with 8375 Agnus and DIP RAM) https://github.com/gazzmaniac/Amiga-SMD-500 > There are issues with the port placements and holes also and I believe...

> You can just load the files into kicad. The BOM is also there. > […](#) > ________________________________ From: kipper2k ***@***.***> Sent: 05 September 2021 19:40 To: SukkoPera/Raemixx500 ***@***.***> Cc:...

The gerbers posted at his site are reported as being bad by jlc. i posted closeups of the errors in his gerbers on his github (that i found). I do...

No worries, i will use my eagle files and cross reference his. I intend on doing the partial assembly too so whoever wants to get most of it soldered should...

I would like to do a 2MB chipmem for this board, i have lots of the 2MB SOJ 42 chips left over from my 8MB fastmem/IDE project, does anyone have...

I have designed an adapter board for the A1000 which doesn't interfere with the PSU and has needed headers for you to attach dupont headers as needed. I will show...

Edit; i need to make a change to design, once i corrected it i will repost

here is my a1000 board layout, it should fit in both Pal/NTSC machines. I had to offset the pi header so the daughter board on the NTSC machine didn't interfere....

Here is my a600 design, tested working fine. It consists of 2 boards and an FFC cable to connect them together.    EDIT: These are the updated gerber...