Joe DeVivo

@ErinCall did you ever get this working? Sorry for the long delay on my side

Ugh. I just opened up the phat-dactyl-bottom-left.scad, which I can only describe as "less than ideal" I think I'll need a little help fine tuning these.

@danielfullmer how do you fasten the top and bottom pieces of your design together?

@danielfullmer ahh, the ol' gravity fastener ;) It'd be nice if there was a way for the pieces to clip together, since I like a good two tone effect. Mind...

Pushed a fix for the row holes on the left board being wired up one pin down from where the need to be on the v02 board The Yellow wire...

@ErinCall, I'm halfway done with the qmk-guide in this repo, but you can see more about how I wired the LEDs [here](http://joedevivo.com/2017/05/20/building-a-qmk-dactyl.html) for now. With QMK all three will flash...

I wrote up a whole thing about [Wiring a Dactyl for QMK/Ergodox-EZ](http://joedevivo.com/2017/05/20/building-a-qmk-dactyl.html) and I'm happy to roll some of that into the guide if that's helpful.

The 220s look like they's supposed to be wired to LEDs, which aren't pictured anywhere. It'd be nice to call that out somewhere and talk a little about how you'd...

I'm also trying to figure out the best way to wire it up to work as seamlessly with qmk as possible. The good news is that at this point I'm...

The HTTP/2 RFC has been finalized. (yay!) The short term goal is to decouple webmachine from mochiweb so that any HTTP server could be used. I don't expect mochiweb to...