jefferyrlc

I'm getting the same issue. Any insight would be most helpful.

I fixed it, on line 178 you need to change print(k.. ": ".. v) to print(k.. ": ".. tostring(v))

Well about 20 so far and no reactor explosions so all good I guess. I am getting the flashing monitor though.

So last night when pushing the reactor to find out what I could do lead to an explosion. It could be me, but it seemed like the auto control for...

did you install it via the readme instructions? if no, then you're missing library files that the program? Other things to check: make sure your computer block itself is setup...

The reactor status has changed. The program is looking for a state of "online" when in reality it's "running" make the appropriate changes to your if statements and it should...

To clarify more the status of the reactor is as follows Cold (was offline) Warming_up (was charging) Running (was online) Cooling_down Abandon_all_hope (reactor is going to explode) And the charged...

I just tested this out again today and it still works for me, pasted below is the exact reator.lua I'm using: -- modifiable variables local reactorSide = "back" local fluxgateSide...

Some other things to point out: make sure your input flux is pointing towards the reactor energy injector, and that your input source is on the other side (the input...

similar crash here Forge: 14.23.5.2772 AE2: rv5-stable-11 EC2: 1.12.2 2.6.1 Crash Report: [crash-2018-12-02_20.07.37-client.txt](https://github.com/ExtraCells/ExtraCells2/files/2637681/crash-2018-12-02_20.07.37-client.txt)