inorhan

I receive the same messages being connected/disconnected to the BMS. disconnected: [17:54:57][VV][scheduler:152]: Running interval 'update' with interval=5000 last_execution=78911 (now=83911) [17:54:57][VV][uart.arduino_esp32:121]: Wrote 0b11011101 (0xDD) [17:54:57][VV][uart.arduino_esp32:121]: Wrote 0b10100101 (0xA5) [17:54:57][VV][uart.arduino_esp32:121]: Wrote 0b00000011...

Tx blinks periodically. Rx stays off. I will try swapping them either way. El lun., 1 nov. 2021 19:51, Sebastian Muszynski ***@***.***> escribió: > Does the TX led of the...

Tested swapping A/B wires for both the new and normal esphome-jk-bms. Still the same. El mar, 2 nov 2021 a las 0:57, inorhan inorhan ***@***.***>) escribió: > Tx blinks periodically....

Can i just change the code in esphome ? Pin4 14 El mar., 2 nov. 2021 8:28, Sebastian Muszynski ***@***.***> escribió: > Could you try to swap the GPIOs at...

1) Original code: A & B no swap / A & B swap= All the esphome sensors remains 0 TX LED in the 485 converter flickers as usual, RX off...

Connected directly (no 485 converters), with original code, swapping/ not swapping 4 / 14 pin, 9600/115200 bps. I always get crazy data in the sensors. Connecting or disconnecting the com...

gnd, tx,rx (tested also without connecting gnd to the ESP). I'm powering the ESP from an isolated 5v PSU. Never used Vbat (red cable from the JST),

You are right, Vbat wasn't connected to the multimeter before... Vbat provides battery voltage correctly.

BTW, there is another github that actually works with the new versions of JKBMS: https://github.com/Louisvdw/dbus-serialbattery/blob/master/etc/dbus-serialbattery/jkbms.py ¿Is this the same protocol that you have implemented ?

Hi, Same issue here. Any luck solving this? Okurono2XLVRV0fB 1.0.2