Thomas

I installed ha some days ago (next to my ioBroker installation) for test. I observed MQTT problems as well. My ems-esp system still reboots after a while (some 3 to...

could the instability come from the mqtt broker? Since I installed a new mqtt broker within homeassistant as add in it seem to be stable now and reconnect works

> Do you like to check the translations and make suggestions? You have to download and compile the v3.5.0 branch. I am happy to support. Do I have to download...

This topic was mentioned in the ioBroker Forum tool. The different solar circuits should be seen in the dashboard and should be accessible by API V3. (solar1, solar2 etc). BTW:...

Is this a house with just floor heating or do you have radiators as well? How many seperate rooms / heating circuits are installed and do they do not have...

@mtvw Difficult to understand the concept of two independent heating circuts with very different setpoint temperatures (9°C different). There must a reason. Ask your installer why, if you don't know....

@mtvw First decide if you would like to control your heating system by outside or room temp. @MichaelDvP I would not recommend to build own components like sensors. The whole...

I do have floor heating and radiators. In some rooms both. The floorheating is reacting very slow on temp changes. The radiators are equipped with homematic thermostats. What I do...

@MichaelDvP you are right Michael, I tested .... but it is still confusing for end-users: Web-API output for read (get) is: 25.04.2022 15:36 For change you need to post: 25.04.2022-15:36:00-0-1...

I do have the same behavior since I upgraded to bookworm on my raspberry pi 4 with docker. Everything works fine: raspberrymatic and iobroker. Just the shim network is not...