bdring

I received the one on Friday. There are a few design issues that make it not 100% compatible with FluidNC at this time. Some of those should be able to...

FluidNC does not read encoders. It can periodically read position information in idle mode from motors with a communications interface. It can do that with the Dynamixel motors now. We...

Only fast enough for human interaction. no more than 10Hz.

Something might be going wrong with the steps/mm. You should do a move of 100mm and measure the distance. Check it before and after homing. This could be due to...

THC has been on the wish list for a long time. It is a big project and we are too busy with basic stuff, support and implementing version 3 of...

Closing. This is on our long term dec list.

Thanks, this looks good. It is probably best to just remove VFDSpindle.h from this PR

I think you just need to return it to exactly the the same state as before the PR.

Fixed your accidental removal of VFDSpindle.h

@RootCNC I would like to add your Discord name and Github name to the header. Are you OK with that. We cannot support this without a test device. Are you...