Ioannis Giannakas

> > Dont delete that little cube - it's used as a handle to move the pattern around. Also best to disable exclude object when running this test. > >...

> > > > Dont delete that little cube - it's used as a handle to move the pattern around. Also best to disable exclude object when running this test....

Thank you for fixing the asserts on pressure equaliser :D

It's because there is no retraction when printing inner outer inner mode. so there is nothing to wipe. We could look at enforcing a wipe operation always even if there...

It would be great if you could do some print tests with the above option enabled (travel distance to 0) and report back with before and after seam shots. This...

Debatable but I get the point. However the super slicer options are filled / not filled and that is purely controlling whether gap fill is applied. Superslicer always respects the...

After shot: 15% overlap, perfection on the top surface without any tiny holes 🎉 

Cool, I'll add the two check boxes and lets take it from there :)

Done - PR updated with 2x tickboxes added to enable gap fill for the corresponding top/bottom and internal solid infill areas. I've set gap fill for top and bottom surfaces...

@SoftFever I've implemented the enum. I've set it to apply gap fill everywhere as the default option, which is consistent with current slicer behaviour. I've also added the option to...