Ioannis Giannakas

It’s an approved vendor from the ERCF team though…

No unfortunately not.

Isn't the issue you are seeing a consequence of under extrusion in the inner layers? Usually these are printed faster which means that the extrusion rate is slightly lower which...

Done, implemented in PR https://github.com/SoftFever/OrcaSlicer/pull/5356

> [Bridge expansion failing_2.zip](https://github.com/SoftFever/OrcaSlicer/files/14067050/Bridge.expansion.failing_2.zip) I have a feeling that the change happened to work for this case. This value serves as a lower bound threshold; technically, it shouldn't even be...

Converting it ti draft to continue experimenting with further prints and see where else this occurs and what the cause could be

Reduce your arc resolution in klipper. Your SBC is too slow to handle higher resolution.

> > Reduce your arc resolution in klipper. Your SBC is too slow to handle higher resolution. > > @igiannakas already at 0.2 , Prime tower btw shouldn’t be using...

It’s not that it’s incompatible, it’s more that it’s pointless as klipper splits the arcs back out to segments (lines) using the resolution setting that you configure in the printer...

No other setting has an adverse effect on Klipper from what I recall. This one specifically is a peculiar one - Marlin and Bambu benefit immensely from this being turned...