Jeff Geerling

@danielkucera - Can you confirm having more than one device plugged in works, identifying all the devices? I noticed that many times it would only show devices plugged into the...

Testing this again with the IOCrest switch but with my 700W power supply for a NAS build... I finally seem to have it powered stably enough to get _two_ devices...

Seems to be extremely stable now (the IOCrest switch). I think for any of these switches, a solid power supply capable of handling 3-5A or more is going to be...

Oliver mentioned I should look for the `aacraid` driver in mainline kernel. Should be a recompile away!

@TheGuyDanish - I'll try to get to it sometime this month. Just a bit backlogged catching up on some other projects still :( Hopefully there's some good data I can...

I bought mine from here: https://www.wdlsystems.com/Innodisk-EGPL-T101-M.2-2280-to-single-10GbE-LAN-Module-0C-to-55C

@dtischler - Very good to know! I'm heading out to pick up the card from Micro Center in a little bit... fingers crossed this experience is a little easier :)

``` $ sudo lspci -v 00:00.0 PCI bridge: Broadcom Limited Device 2711 (rev 20) (prog-if 00 [Normal decode]) Flags: fast devsel Bus: primary=00, secondary=01, subordinate=01, sec-latency=0 I/O behind bridge: 00000000-00000fff...

Same BAR address space issue as the Zotac GeForce GT 710: ``` [ 1.047548] pci_bus 0000:01: busn_res: [bus 01-ff] end is updated to 01 [ 1.047591] pci 0000:00:00.0: BAR 9:...

Well that's weird. I extended the address range and am still gettting: ``` [ 1.006265] brcm-pcie fd500000.pcie: host bridge /scb/pcie@7d500000 ranges: [ 1.006284] brcm-pcie fd500000.pcie: No bus range found for...