Jeff Geerling

@angelia-gt - I'm not sure what you're asking... I order most of these things from Amazon, and you seem to be asking a lot about order numbers...?

@lealog - I've been testing through Alftel's [Seaberry board](https://pipci.jeffgeerling.com/boards_cm/seaberry.html), and through their [12-slot M.2 A+E key carrier](https://pipci.jeffgeerling.com/cards_m2/alftel-12x-pcie-m2-carrier-board.html) on a CM4 IO Board as well.

@scrappylabs - Now that you have it working... it'd be interesting to see if you could run some speedtests to some more-than-1 Gbps targets and see how fast you can...

@scrappylabs - For iperf3 the ideal would be to run it on the AP itself but that's not usually possible. Failing that, on another computer on the network (ideally connected...

With the 1 to 2 ports adapter, I'm able to get multiple devices to load, so that's nice: ``` $ lspci 00:00.0 PCI bridge: Broadcom Limited Device 2711 (rev 20)...

To test NVMe + SATA, or anything plus anything requiring extra power... I'm going to need to grab an external PSU. I just don't have enough adapter cables to get...

The PSU is quite girthy, and also has to have a jumper across two pins on the motherboard connector so it will switch on. That was unforeseen, but obvious in...

@Chaz6 - I'm actually going to try another switch, which might also be nice on the CM4, though it will likely cause a bit of strain on the connector... https://www.ebay.com/itm/PCIe-1x-to-Dual-PCIe-1x-90-Degree-Riser-Card-with-Power-PCIe-Switch-Expansion/273855896755?hash=item3fc3155cb3:g:fVwAAOSwHu5c4uvd

@markus-k - I can't speak to @Chaz6's card, but the IO Crest seems to so far only work with devices plugged in through slot 2 (maybe slot 1 is dead,...

I also wanted to post an update—earlier I do remember having at least the Marvell 9215 (IO Crest) SATA card and Samsung 970 EVO NVMe working at the same time...