Jeff Geerling

This change breaks the role's idempotence, however—it forces the service to be stopped any time it runs...

I'm looking at the CI job for this branch (see the checks listed at the bottom of this PR), which is showing up as having idempotence tests failing with this...

Indeed! I have one of these boards to test—I think there may have been some concerns over the interfaces working correctly on the Pi 5, and I'm planning to test...

On the site here: https://pipci.jeffgeerling.com/hats/radxa-dual-2.5g-router.html For now I'm listing it as 'prototype' since I don't see it available for sale anywhere yet.

Just booting it the first time, a few observations: 1. When I plugged in my 12V barrel plug, I got a nice little spark out of the connector. Always a...

I tried adding `dtparam=pciex1_no_l0s=on` to `/boot/firmware/config.txt`, and ... it says it's enabling the device in dmesg: ``` pi@pi5:~ $ dmesg | grep nvme [ 2.623758] nvme nvme0: pci function 0000:03:00.0...

Regarding power draw, if I have the Pi powered off normally, with a base Pi setup and no tweaks, I see about 3W of power draw shut down. Following [my...

If I unplug the NVMe drive, so that socket is empty on the top, the 2nd 2.5G Ethernet port isn't working. I see the 1st port, but port 2 doesn't...

I also tested a Pineboards HatDrive! M.2 HAT plugged into the FFC on the board, and it didn't light up the PWR LED at all, nor did the drive show...

Testing with an Inland 256GB 2280 NVMe SSD, I see it with lspci: ``` 0000:03:00.0 Non-Volatile memory controller: Silicon Motion, Inc. SM2263EN/SM2263XT SSD Controller (rev 03) ``` But again, no...