geduxas

If it's help's, what i am trying to accomplish, is to make automatic adjustments for heating pump. I have setup, where i can adjust temperature shift by increasing by 5...

heating curve parameters should still be in configuration. Because they are independent, and accessible by telemetry independent heating mode.. (never tested by myself) as for time scheduler, it's really interesting...

To what pump do you try to connect, and in which connector? Share some photos of your setup.

Yes i think you should take photos of your board, and check connection, it should be connected to cn-cnt, other connection is for parallel work with cz-taw. Heishamon should get...

Could it be that your pump hase locked out cn-cnt? Have you tried power cycle your pump (disconnect power by breakers)?

How it could be that both are broken in same time? Really it should be hard way to broke them.. As you have taw adapter, you could attach one of...

No, it's really simple setup, all is required serial connect to pump and power.. in your case something is wrong with serial.. it's not in socket/wire is broken/using wrong wire.....

@Tom54497 by manual, demand control is same in J and H series. Difers only SGReady (if i remember it correctly) terminals, which you can set as push button's and reduce...

I have optional pcb, now need to find out controller 0-10V and just test it.. i am doubt that Heishamon emulation is doing something wrong... Indeed never tested that.. @Tom54497...

> If I will install real Optional PCB, then is it will be possible still sending demand commands via MQTT? Why you need set it with optional board? Just add...