Florian Festi
Florian Festi
As noted in https://hackaday.io/project/10649-boxespy/discussion-176555 slots don't do well with tight fits. There needs to be an option to make them wider without changing the `burn` value. This is not 100%...
Extend the existing finger joint edge or create a new one that is form-locking. Make the finger stick out two thinknesses and have a notch on both sides. Render a...
Right now Boxes.py writes an SVG file to disk and then reads it back in to merge it with the Inkscape file. This was necessary as libcairo would not allow...
While we have a parameter in the flex settings it is often not used. May be the flex edge should use is directly. But this would require an opposing edge...
to be able to keep the lids closed.
Passing the parameter in the URL is very nice for many use cases. But the Online instance chops off the URL if it gets too long which can easily happen...
Looks like my suspicion about Zanata where justified and the service is not longer properly supported. So we either need to move somewhere else or have translations edited via GitHub...
Many generators only have very generic descriptions - only repeating the name as a sentence. Descriptions should stay short but add information to the generator name.
Generator should have a longer description than may include assembling instructions or limitations that is shown on the generator page (in contrast to the "description" that shows up in the...
While the library supports "bed bolts" (slots for nuts and screws holding walls together at joints) the generators don't.