fietser28
fietser28
The 5 pin connector of the DCP405 front panel is not flat with the front side of the panel (is is recessed). This works fine for the supplied push-in connector,...
Make the rprog (voltage or current) honor the Vset/Iset limits. In normal operation I always set things low to avoid magic smoke. With prog currently the voltage limit is completely...
To power small auxiliary extension that are connected to the BB3 it is usefull to have an additional port or make explicit which port power can be drawn from. These...
In the current implementation of the DCP405 Rprog setting is done relative to the internal GND of the DCP405. This makes it impossible to connect a AWG with GND to...
It seems source:volt? always returns the fixed value and not the value generated by the funcgen if it is active. Example in simulator:  How to reproduce: Set the value...
 P2 should read 0,4889 W. DC power source is used, all numbers are stable. AC analysis is correct: 
When using the AFE3 a common use case is to measure the efficiency of a mains powered power supply directly with the BB3 only. This currently doesn't work because the...
When AC analysis is enabled and I log DLOG values from the MIO168 there will be a glitch in the recording between 50-70 ms after the start of the recording....
With the following settings in function generator: DCP#2, DOUT1, AOUT1 all to pulse, 200ms period, 50ms pulse width:    When I turn the output on, this is shown...
The current development version of the firmware (1.8) is not compatible with the V2 resource files for python scripts generated with studio that are being used with versions 1.8 -...