dynfer
dynfer
This PR allows the use of the CAN controller created by the RusEFI project based on the stm32f042 and stm32f103. The module works on ID 400 and can be further...
Hello, I have two f0 boards which have two different behaviours, both running November firmware from mck1137/wideband. 1. Nerst voltage fluctuates depening on the applied oxygen (sensor over candle or...
Overview: 1UZ-FE 36-2 VR crank into proteus VR1 single tooth cam into proteus VR2 RPM happens to drop below current real value happens at idle around 800-> 200rpm and during...
This PR adds a table where based on CLT we set different cranking angle. Certain engines tend to have different angles per their temp also this will help e85 users.
Certain engines preffer different advance values based on CLT temp while cranking. Currently we only support Cranking advance vs cranking RPM
In theory we should be able to detect misfires based on the trigger angle error. If a misfire happens the crank will slow down resulting in a tooth arrving late....
Use a rolling cut limiter for launch and revlimiter that would allow a customizable % of ign events to be skipped (fuel, spark. both)
Hello, Suggestion to add virtual inputs and a menu in TS to allow for easier use of can input data without lua to make it more attractive to users without...
Suggestion to rework the current 2 curves for handling dwell settings into a single 3d table, this would reduce the confusion with the multiplier and would allow for more granullar...