dp250f
dp250f
Thanks for the detailed info. I agree on all points - and since discovering the KODI zuki.pvr.hdhomerundvr plugin I've been working on setting it up. I'm switching from Plex DVR...
I would also like this feature as it would make Organic and Snug supports easier to remove when using a smaller z-gap. Gives you something to pry on/against or grab...
Oh. That's too bad. The ability to fine-tune Z-contact distance is one of the reasons I prefer PrusaSlicer. Hopefully this functionality can be added to Organic supports in the future.
> This should be handled by the FW. Prusa Printers, for example, have this implemented, the fan receives a short strong impulse to help spin it before every fan command...
It bothered me that I couldn't use the SD card reader in 12864 mode on my TFT35 v3.0, so I figured out how to wire up the SD Card pins...
Reformatted the USB drive. Still displays error on cold boot and not on reset. I also tried without the USB drive and it boots normally. Other than the error message...
Bought a new flash drive, formatted FAT32. Still the same thing happening.
Built and flashed 6.0.0 release today. Issue persists.
I also noticed this when trying to apply a negative value to retract_restart_extra_toolchange. It would also be nice to have this and retract_length_toolchange added to filament setting overrides.
Get-OSBuilds, Get-OSMedia, and Get-OSImport are all missing 24H2 in their OSReleaseId parameters. New-PEBuildTask, New-PEBuild, and New-OSDBuildTask also need to have 24H2 added.