Cliff
Cliff
Since the GUI is written in Qt it should compile for Android too. There are probably going to be some issues but the biggest issue i can see is the...
Apparently you have to root your phone to get android USB serial port working 👎 Which means a big code change to use over BT. don't expect this one anytime...
Mission planner on android now!! Love it. Was doing some reading on QSerialPort in QT and there were lots of comments about CDC not working. Didn't even think to see...
Well that compiled a lot easier than I thought it was going to go. Last time I tried QT with android the setup was a b.... wasn't too bad at...
**Update:** After browsing and trying out code from QGroundcontrol I'm pretty sure this is going to work just fine without having to go directly via BT or any rooting. Looks...
Was looking at this idea a little while ago and started working on a JSON based BLE interface to the current serial data. Thinking about using WebBLE and (slowly...) working...
Agree, that it would be good to use this as an editor too. The GUI was originally built to support more than one board, which switched the layout a bit...
No unfortunately not, it's hardwired to the chip reset. and can't override it.
@AndersN76 - Sorry, I see what you actually mean. Some working options are, * Opening your radio and rewiring a switch. Then run wires to the Headtracker. (Works will all...
Moving this to a new issue to make it more visible. It's written in QT and I tried to keep everything as cross platform as possible so yes it should...